Software Management

swacl :-The swacl command displays or modifies the Access Control Lists (ACLs). These ACLs protect the specified target selections (hosts, software depots or root file systems) and the specified software selections on each of the specified target selections (software depots only)

swconfig :-The swconfig command configures, or reconfigures installed software products for execution on the specified targets. The swconfig command transitions software between INSTALLED and CONFIGURED states

swcopy :-This command copies or merges software selections from a software source to one or more software depot target selections. These depots can then be accessed as a software source by the swinstall command

swinstall :-The swinstall command installs the software selections from a software source to either the local host or, in the case of the HP OpenView Software Distributor product, to one or more target selections (root file systems). By default, the software is configured for use on the target after it is installed. (The software is not configured when installed into an alternate root directory.)

swlist :-The swlist command displays information about software products installed at or available from the specified target selections, that is, depots. It supports these features:

• Specify bundles, products, sub products, and/or filesets to list.

• Display the files contained in each fileset.

• Display a table of contents from a software source.

• Specify the attributes to display for each software object.

• Display all attributes for bundles, products, subproducts, filesets and/or files.

• Display the full software specification to be used with software selections.

• Display the readme file for products.

• Display the depots on a specified host.

• Create a list of products, subproducts, and/or filesets to use as input to the other commands.

• List the categories of available or applied patches.

• List applied patches and their state (applied or committed).

swreg :-The swreg command controls the visibility of depots and roots to users who are performing software management tasks. It must be used to register depots created by swpackage

swremove :-The swremove command removes software selections from target selections (for example, root file systems)

swverify :-The swverify command verifies the software selections at one or more target selections